Z Offset Changes Not Persisting After Reboot with Eddy Duo (USB) on OpenNept4une

[ytemucin16-commits]

Hi everyone,

I installed OpenNept4une on my Neptune 4 Pro and upgraded to an Eddy Duo probe running over USB. The printer is working without any major issues.

Here is the problem:

• I set the Z offset normally and do the paper test.
• I save the settings successfully.
• After that, I run a first layer test print.
• The first layer comes out rough / scratchy, so I adjust the Z offset again using babystepping during the print.
• I save the new offset.

At this point, the first layer looks correct. However, after rebooting the printer, the babystepped Z offset adjustment is lost and it returns to the previous value.

Is there an additional step required to permanently save babystepped Z offset values when using Eddy Duo over USB on OpenNept4une?

Thanks.